Escort Prism 20401 Spezifikationen PDF herunterladen (Seite 98)

7-1

Chapter 7 – System & Parameter Messages

System and parameter messages remind, prompt, or warn you about the current condition of the

monitor or its parameters. These messages are displayed in reverse video and may flash on and

off to get your attention.

System Messages

The system messages, explained in the following tables, are displayed in a reverse-video box, just

below the WDZ. They apply to conditions of the monitor that are not specific to any one

parameter. See the “System Message Area” section for more information.

System Messages

SYSTEM MESSAGE MEANING

RECORDER PAPER The recorder is out of paper, or the paper is not installed

correctly.

REC DISABLE FREEZE You are trying to freeze waveforms while recording is in

progress. You can only freeze waveforms when they are not

being recorded.

REC IN CONT RUN MODE Indicates that you have pressed and held the RECORD key so

that the recorder will run continuously. Press RECORD again to

end continuous recording.

FREZ RELEASE FREZ Waveforms are currently frozen. To release the frozen

waveforms, you must press either the FREEZE or the RECORD

key.

LINK RECORD SENT A record has been sent to the Central Station because the recorder

at PRISM monitor is either not present or out of paper.

ALARM SUSPEND XXX You have pressed the ALARM SUSPEND key, disabling all

alarm tones for the number of seconds (XXX) displayed. To

enable alarm tones before the suspend time has expired, press the

ALARM SUSPEND key again. The ALARM SUSPEND

function is also enabled at power-up.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 169 170

Keine Kommentare

Escort Prism 20401 Spezifikationen Seite 98