Escort Prism 20401 Spezifikationen PDF herunterladen (Seite 45)

3-4

Selecting a Telemetry Patient to Monitor

“Telemetry-monitored” patients must be prepared properly for telemetry functions to work. A

3-lead or 5-lead ECG cable (depending on the type of transmitter used) must be correctly

connected to both the patient and the telemetry transmitter. The transmitter must then be secured

to the patient with an appropriate transmitter pouch.

1. Open the ECG SETUP menu by pressing the softkey next to the ECG label.

ALM

OFF

ALM

LIM

SIZE

LEAD

SEL

PACE

OFF

2. Press the MORE softkey twice to access the third ECG Setup Page.

TLM

 

TLM

 

MODE

CABLE

TLM

3. Press the MODE softkey to select TLM (telemetry) if it is not already selected.

4. Press the TLM ID UP ARROW   or DOWN ARROW   softkeys until the transmitter

ID of the patient you wish to monitor appears in the ECG numeric display zone, directly

under the heart rate numerics.

NOTE: If you cannot find the transmitter ID of the patient you wish

to monitor, they may not be setup correctly. Contact service personnel

to perform this procedure.

5. Press the PAGE HOME key to activate your selection and return to the main

monitoring screen. Telemetry ECG monitoring will begin automatically.

Correcting CHK Leads (Check Leads) Errors

If a CHK LEADS message is displayed on the screen after connecting the patient cable to the

monitor or anytime during monitoring, check the following:

 The ECG cable, lead wires, and electrodes are properly and firmly connected

 Electrodes are not excessively dry

 The lead selected can be monitored with the ECG cable and lead wires currently connected

(for example, you are trying to monitor a V-lead with a 3-lead cable)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 169 170

Keine Kommentare

Escort Prism 20401 Spezifikationen Seite 45