Escort Prism 20401 Spezifikationen PDF herunterladen (Seite 100)

7-3

SPO2 Messages

SPO2 MESSAGE MEANING

SPO2 SRCH

(Nellcor only)

The monitor cannot locate the patient’s pulse. The patient’s

perfusion may be too poor to detect an acceptable pulse. Confirm

proper application of the sensor; make sure the ECG parameter is

available for C-LOCK synchronization; try another sensor site; or

try the OXISENSOR II R-15 sensor.

NO C-LOCK

(Nellcor only)

Indicates loss of synchronization between the ECG and SPO2

pulse waveform. Take steps to eliminate ECG artifact, or if the R-

wave amplitude is less than 4 mm, increase the ECG waveform

size by using the ECG SIZE softkey.

NO SENSOR The SPO2 parameter is ON, but the sensor and/or sensor cable

is/are not connected to the monitor.

SPO2 CAL The monitor is performing automatic self-calibration. The

calibration range is 50 to 100%.

Invasive Blood Pressure (BP1/BP2/BP3) Messages

BP1/BP2/BP3 MESSAGE MEANING

NO XDUCER The pressure transducer is not connected to the monitor.

ZERO BP1

ZERO BP2

ZERO BP3

Message flashes until the pressure channel is zeroed as a

reminder that pressures must be zeroed prior to use.

NO ZERO: PULSE DETECT Displayed over the BP SETUP page to indicate that either a pulse

or electrical noise was detected, which precluded zeroing the

transducer. Confirm that the transducer is vented to air before

pressing the ZERO key.

ZERO OUT OF RANGE Displayed over the BP SETUP page to indicate that a

transducer’s offset exceeds the zero range (±100 mmHg) of the

monitor. Confirm that the transducer is vented to the air and

attempt to zero again.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 169 170

Keine Kommentare

Escort Prism 20401 Spezifikationen Seite 100